When the woodworking sanding machine is operated, people should stand in the middle of the left side of the workbench. The front desk is slightly lower than the front desk than the front desk. Generally, it does not affect the normal operation of the knife shaft and the speed of feeding. When the soft and narrow vertical planing, the amount of knife can be larger; otherwise, the amount of knife should be smaller. When the required size is about to be planed, the amount of snack knife should be reduced. The difference in height is the thickness of the planing, generally controlled at 1-2.5mm. To start the machine, the workpiece can be shaved after the knife shaft is running normally. The amount of knife for shaving should not be too large, and the planing speed should be properly controlled to keep the knife shaft running normally. When planing, the planing should be adjusted according to factors such as the hard and hard of the workpiece material, the direction and width of the wood fiber texture and width of the processing surface.
During the woodworking sanding machine operation, according to the requirements of the workpiece planing surface, adjust the workbench. The front desk is slightly lower than the background. To start the woodworking sanding machine, the workpiece can be shaved after the knife shaft is running normally. The amount of knife for shaving should not be too large, and the planing speed should be properly controlled to keep the knife shaft running normally. When planing, the planing should be adjusted according to factors such as the hard and hard of the workpiece material, the direction and width of the wood fiber texture and width of the processing surface.
When woodworking sanding machine planing with a combined workpiece, you should first check whether the metal parts such as round nails or screws should be planed; if there are, you can use nails to pour the round nail or use the rotary chisel and then scratch. At the same time, it is necessary to check the edges to avoid damaging the knife. In the case of normal operation of planing workpieces, protective hoods should be used to ensure safety. When a short item of 400mm and thickness of less than 30mm thick, use a push roller to feed. The thin plates with a length of 400rNm and a thickness of less than 30mm should be used to use the push plate to avoid hurting the hands. Woods with a length of 300mm and less than 20mm should not be planed on the flat plane machine. Instead, the short workpieces and small workpieces should be prepared into multiple materials and large materials. After the plane is cut, it should be cut to ensure safety.
Post time: Jun-09-2022