If the edge banding machine is frequently used daily and the maintenance is not in place, it will lead to the premature aging of the edge banding machine equipment over time, thereby shortening the service life, so the daily care and regular maintenance of the edge banding machine are essential.
The maintenance and maintenance of the edge banding machine mainly include the following basic operations:
Regularly refuel the operating machine.
Regularly check whether the screws are loose. Once they are found to be tightened immediately, the screws should be replaced if necessary.
Clean up the excess glue and sawdust on the edge banding machine in time to keep the machine's operating surface clean.
Clear the waste around the edge banding machine in time to keep the operating area clean.
Symptomatic repair of the complete knocking of the fully automatic edge banding machine. As the operator of the edge banding machine, we all know that the head knocking plate of the automatic edge banding machine is easy to be damaged. Once this happens, the repair methods are as follows:
The backward downward speed may be too fast or the downward pressure is too large, which will cause the board to hit the board by the ruler.
Solution: After adjusting the head cylinder inlet/exhaust pressure regulating valve, all the downward speed force is reduced.
The upward pressure of the front head is too large, and the plate hits the front ruler when traveling
Solution: adjust the pressure of the upward pressure regulating valve in front of the edge banding machine to make the force soft.
The position of the travel switch of the forward downward signal will be misaligned. It will also happen that the plate travels to the predetermined position without touching the travel switch or directly knocking off the switch, resulting in no signal and knocking of the board.
Solution: adjust the position of the travel switch, and replace it if it is seriously damaged.
The edge banding machine's head and ruler guide wheels are missing, resulting in knocking.
Solution: replace the guide wheel
There are burrs on the contact surface of the edge banding machine.
Solution: Use fine gauze to grind off.
During the use of the edge banding machine, if you find that the processing of the edge banding machine affects the quality of the product and it is difficult to achieve proper alignment, you need to check the edge banding machine itself.
The maintenance of the edge banding machine or the inspection of the quality of the edge banding machine can start from the following aspects;
Check the pneumatic device to see if it meets the needs and adjust or replace it
The powerful head and pressure must be adjusted accordingly
Choose a suitable PVC plastic heat sealing machine head, to ensure that it can make the pressure of the PVC plastic heat sealing machine uniform, and the up and down state is stable
The pressure of the mechanism should be adjusted arbitrarily according to the needs to meet the needs of different welding depths. The head is flexible and convenient and equipped with double springs. The edge banding machine has a light pedal force and reaches the pressure standard.
The frequency of the edge banding machine should be standard and stable, and the oscillation frequency adopts the international industry standard 13.68 MHz, 27.12 MHz, and 40.68 MHz frequency bands.
Post time: Oct-25-2021